Dear Rick - Just a note of thanks to you and your staff for the very competent and efficient attention to all the details of my marine railway and dock installation this past summer. It has been a pleasure to be on the receiving end of your excellent service, and the job you have done is most satisfactory in every way. - Thank you, Dr. Paul Bodrug
MANUALS & INFORMATION
Here's where you’ll find useful information about how to maintain your products. You’ll also find manuals for various products we sell
| PWC Lift Installation.pdf | Pick a convenient spot to place your watercraft lift. Ensure the bottom has a solid base before setting the lift. It may be necessary to place patio slabs on the bottom for the base feet to sit on to ensure a solid placement. All adjustments and installations should be made with the top bunk in the fully raised position... |
| City of Peterborough6.pdf | Letter of reference from the City of Peterborough regarding the quality and installation of the Peterborough Marina Docks and Mark St. Docks. |
| R&J Price List 2012_WEB.pdf | Download a copy of our 2012 Price List |
| Equa Dock Assembly Instructions.pdf | The "Equa Dock" can be configured in many different ways. For example as an end to end, a side to side or a side to an end dock. Determine which configuration you are going to assemble the dock then that will determine where the leg supports and connecting brackets will be assembled to... |
| Wheel In Dock Installation.pdf | Slide the wheel unit under the dock with the sliding end to the front of the dock. This is the end with the caps... |
| Boat Lift site Installation.pdf | It is critical to have the legs resting on a flat, solid bottom to ensure the lift will remain level. Concrete slabs or flat rocks are a good base. Minor adjustments may be required after the boat has been placed on lift to ensure the desired level is maintained... |
| Lift Up Dock - Lifting Instructions.pdf | Before you can prepare to lift your dock, you must first remove all the deck boards. It is advisable to start at the far end and remove to the shore keeping track of the order of removal so they can be re-installed in reverse order and all will fit properly!... |
| Marine Railway site Installation.pdf | Set nose cone down on the ground where you will be securing It to. At this point decide what is required to properly slope the section so the carriage will freely roll... |
| Placement Of Deck Board Sections To Dock Frame.pdf | After removing the trim strips, it is recommended to replace all the screws back into the nuts in the channel and slightly tighten. This will prevent the nuts from sliding down the channel while lifting... |
| Vertical Lift.pdf | Assemble lower horizontal side supports to Upright vertical frame... |
